MITSUBISHI CNC
2 GOT Initial Setup
(2) Select the following items from among the pull-down menu, and click "OK".
GOT type: Select the model name of the GOT to use ("GT16**-...")
(3) The "Controller Setting" dialog is displayed. Select the following items among the pull-down menu.
Extend I/F-1 1st
Controller Type: MELSEC-QnU/DC, Q17nD/M/NC/DR, CRnD-700
I/F: Extend I/F-1(1st)
Driver: Bus(Q)
(Note)
Select "Extend I/F-2(1st)" when the bus communication unit is mounted on the GOT rear slot IF-2.
16