Mitsubishi Electric C70 Setup Manual page 198

【#1041(PR)】 l_inch Initial state (inch)
Select the unit system for the program travel amount when the power is turned ON or reset and for
position display.
0: Metric system
1: Inch system
(Note) Selection of inch and metric unit
(1) Tool compensation amount (Tool length compensation amount, tool wear compensation amount
(2) Workpiece coordinate offset
(3) Machining parameter
(4) Axis parameter
(5) Barrier data
(6) Base specifications parameter
【#1042(PR)】 pcinch PLC axis command (inch)
Select the unit system for the commands to the PLC axis and the PLC indexing axis.
When changing the NC axis/PLC axis switchover to the PLC axis control, the command unit is set in
accordance with the parameter setting.
0: Metric system
1: Inch system
【#1043】 lang Select language displayed
Select the display language.
0: English (Standard)
1: Japanese (Standard)
11: German (Option)
12: French (Option)
13: Italian (Option)
14: Spanish (Option)
21: Polish (Option)
22: Simplified Chinese (Option)
【#1044(PR)】 auxno
Not used. Set to "0".
When the setting value of "#1041 I_inch" is changed, the unit of length is changed after reset.
The following parameters concerning length, however, are not changed automatically. Change
the setting values of following parameters according to the new unit system.
and tool tip compensation amount)
#8004 SPEED ("#8004 SPEED" is 10 inches/min. unit for the inch system. )
#8005 ZONE r #8006 ZONE d
#8010 ABS. MAX. #8011 INC. MAX.
#8013 G83n #8016 G71 MINIMUM
#8018 G84/G74n
#8204 OT-CHECK-N #8205 OT-CHECK-P
#8206 TOOL CHG.P #8209 G60 Shift
#8300-#8306
Appendix 1.3 Base Specifications Parameters
#8009 DSC. ZONE
#8012 G73n
#8017 G71 DELTA-D
#1084 RadErr
C70 Setup Manual
181