Mitsubishi Electric C70 Setup Manual page 217

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
bit B: Group 12 Workpiece coordinate system modal initialization
bit A: (Not used)
bit 9: Group 10 Fixed cycle return command modal initialization
bit 8: (Not used)
bit 7: (Not used)
bit 6: Group 7 Nose R compensation modal initialization
bit 5: Group 6 Inch/metric modal initialization
bit 4: Group 5 Feed G modal initialization
bit 3: Group 4 Barrier check modal initialization
bit 2: Group 3 Absolute/incremental command modal initialization
bit 1: Group 2 Plane selection modal initialization
bit 0: Group 1 Move G modal initialization
【#1211】 FHtyp Feed hold stop type
Select the type of the external signal used for feed hold.
0: Disable the external signal.
1: Enable the external signal (contact A)
2: Enable the external signal (contact B)
---Setting range---
0 to 2
【#1212】 FHno Feed hold external signal device
Set the device No. (X**) used to input the feed hold signal.
---Setting range---
000 to 2FF (hexadecimal)
【#1216】 extdcc External deceleration level
Set the upper limit value of the feedrate when the external deceleration signals are enabled.
This parameter is valid when "#1239 set11/bit6" is set to "0".
---Setting range---
1 to 1000000 (mm/min)
200