Mitsubishi Electric C70 Setup Manual page 231

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1388】 Alm42Bord Alarm displaying threshold (42)
Set threshold for turning ON the detector alarm (42).
The threshold is "1" when "0" is set.
---Setting range---
0 to 3
【#1493(PR)】 ref_syn Synchronization at zero point initialization
(Note) Set to "1" for position command synchronization control.
0 : Primary axis and secondary axis determine their zero points individually.
1 : The zero points of both primary and secondary axes are determined by initializing the primary
【#1496(PR)】 push_typ Stopper method at zero point initialization
0 : Follows #1493.
1 : When #1493=1 and both the primary and secondary axes reach the current limit when using the
【#1501】 polyax
Not used. Set to "0".
【#1505】 ckref2 Second reference position return check
Select whether the check is carried out at the specified position in manual second reference position
return mode upon completion of spindle orientation or at second reference position return interlock
signal.
0: Upon completion of spindle orientation
1: At second reference position return interlock signal
【#1510】 DOOR_H
Not used. Set to "0".
【#1511】 DOORPm
Not used. Set to "0".
【#1512】 DOORPs
Not used. Set to "0".
【#1516】 mill_ax Milling axis name (rotary axis name of polar coordinate interpolation)
Set the name of the rotary axis used in milling interpolation. Only one rotary axis can be set.
---Setting range---
A name for the rotary axis: "C", "B", etc.
【#1517】 mill_C Hypothetical axis command name
Select the hypothetical axis command name for cylindrical interpolation/polar coordinate
interpolation.
This parameter corresponds to the rotary axis name.
0: Y axis command
1: Command rotary axis name.
【#1520(PR)】 Tchg34 Additional axis tool compensation operation (for L system only)
Select axis to carry out the additional axis' tool compensation function.
0: 3rd axis.
1: 4th axis.
214
axis' zero point.
When using the stopper method and either the primary axis or the secondary axis reaches the
current limit, both axes proceed to the next step.
stopper method, the droop will be canceled and both axes proceed to the next step.