Mitsubishi Electric C70 Setup Manual page 493

MITSUBISHI CNC
Appendix 2 Explanation of Alarms
Z83 During spindle rotation NC ON 0001
Details
NC has started while the spindle is being rotated.
Remedy
- Turn the power OFF to confirm that the spindle has stopped, and then turn it ON again.
Z89 APLC ERROR 0001
Details
C language module is not adequately stored in NC in APLC release.
Remedy
Resend the C language module.
Z89 APLC ERROR 0002
Details
SRAM size exceeded 16KB in APLC release.
Remedy
Make the SRAM size to 16KB or smaller.
Z89 APLC ERROR 0003
Details
DRAM size exceeded 512KB in APLC release.
Remedy
Downsize the DRAM to 512KB or smaller.
Z89 APLC ERROR 0004
Details
APLC module does not include initialize function aplc_top, dramSizeCheck, sramSizeCheck, or
setUserBaseMain.
Remedy
Check if APLC module includes the above functions.
Z89 APLC ERROR 0005
Details
The contents of APLC module in FROM is illegal and cannot be loaded.
Remedy
Check the contents of APLC module.
* Check if it does not include an undefined function."
Z89 APLC ERROR 0006
Details
APLC was activated during APLC invalid mode.
Remedy
Change to APLC valid mode.
Z99 FILE AREA ERROR 0001
Details
The edited data is destroyed probably because it was not properly updated and the backup operation
did not complete normally.
Remedy
Format the area again.
476