Setting Base Specifications For Each Axis - Mitsubishi Electric C70 Setup Manual

6.2.2 Setting Base Specifications for Each Axis

(1) Touch the page scroll key to display the "BASE SPEC. PARAM" screen (SETUP 1. 2/22), and set the following
parameters according to the machine specifications.
(Note) The number of screens (pages) and their contents are different depending on the number of axes and part
systems set in the previous section. (If the number of axes to use exceeds eight, pages will be automatically
added.)
Turn the power OFF and ON in order to validate the axis setting.
#1013 axname: Set each axis' name. The characters that can be used for axis names are the alphabets X, Y, Z, U,
V, W, A, B, and C, and numerical characters.
#1014 incax: Set the axis name when commanding an incremental value for the axis travel amount.
#1015 cunit: Set the minimum increment of program travel command.
(0: Follow "#1003 iunit", 1: 0.1μm, 10: 1μm, 100: 10μm, 1000: 100μm, 10000: 1.0mm)
#1016 iout: Select the unit system used for setting mechanical value (ball screw pitch and position detection unit).
(0: Metric system, 1: Inch system)
#1017 rot: Select whether the axis is a rotary axis or linear axis. (0: Linear axis, 1: Rotary axis)
#1018 ccw: Select the direction of the motor rotation to the command direction. (0: Clockwise, 1: Counterclockwise)
#1019 dia: Select the command method of program travel amount. (0: Command with travel amount, 1: Command
with diameter dimension-Actual travel amount is half of it)
This parameter is normally set for Lathe system' s X axis.
#1020 sp_ax: Select "1" when using the spindle for the counter control of NC axis (C-axis).
#1021 mcp_no: Set the number to specify the drive unit.
First two-digit: Set to "10" (fixed value).
Last two-digit: Set the value of the drive unit's rotary switch SW1 +1 (in hexadecimal ).
6.2 Setting the Axis Configurations (NC axes, PLC axes, Spindle)
C70 Setup Manual
103