Mitsubishi Electric C70 Setup Manual page 215

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1210】 RstGmd Modal G code reset
Select whether to initialize G code group modals and H and D codes, which corresponds to bits as
follows, when the system is reset.
0: Initialize.
1: Not initialize.
<Description of bits for M system>
1F 1E 1D 1C
0 0 0 0
F
0 *
bit 1F: (Not used)
bit 1E: (Not used)
bit 1D: (Not used)
bit 1C: (Not used)
bit 1B: (Not used)
bit 1A: (Not used)
bit 19: Spindle clamp rotation speed initialization
bit 18: H, D codes initialization
bit 17: (Not used)
bit 16: (Not used)
bit 15: (Not used)
bit 14: (Not used)
bit 13: Group 20 2nd spindle control modal initialization
bit 12: Group 19 G command mirror modal initialization
bit 11: (Not used)
bit 10: Group 17 Constant surface speed control command modal initialization
bit F: (Not used)
bit E: Group 15 Normal line control modal initialization
bit D: (Not used)
bit C: Group 13 Cutting modal initialization
bit B: Group 12 Workpiece coordinate system modal initialization
bit A: (Not used)
bit 9: Group 10 Fixed cycle return command modal initialization
bit 8: (Not used)
bit 7: Group 8 Length compensation modal initialization
bit 6: Group 7 Radius compensation modal initialization
198
1B 1A 19 18 17 16 15 14
0 0 * 0 0 0 0
*
E D C B A 9 8 7 6
0 * 0 * 0
* * *
13 12 11 10
* * * *
5 4 3 2 1 0
0 *
* * * *