How Can I Set Netcol8000-A Parameters (Modbus-Tcp) - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
----End
8.7.22 How Can I Set NetCol8000-A Parameters (Modbus-
TCP)?
Prerequisites
One end of the straight-through cable has been connected to the FE port on the
NetCol8000-A main control board, and the other end has been connected to the
LAN port on the ECC800-Pro, PoE port on the smart ETH gateway, or PoE port on
the busway.
Procedure
Step 1 Set NetCol8000-A monitoring parameters.
1.
2.
3.
Step 2 Set the running parameters and control parameters for the NetCol8000-A on the
WebUI.
1.
2.
3.
4.
Issue 04 (2021-10-09)
CA UTION
After the smart cooling product is shut down, the temperature of the smart
module increases and data running is affected. Exercise caution when
performing this operation.
Enter the NetCol8000-A home screen, tap Settings, choose the user name
admin and enter the password 000001. After login, the settings screen of the
NetCol8000-A is displayed.
Choose Settings > Comm Settings > LAN IP Settings, set LAN IP assigning
mode to Automatic(DHCP), and tap Submit.
Choose Settings > Comm Settings > Modbus Settings, and set Connection
mode to Server and client, Server encryption to Enable.
NO TE
After the NetCol8000-A parameters are set, the ECC800-Pro can automatically identify the
NetCol8000-A.
Log in to the ECC800-Pro WebUI as an administrator.
Choose Monitoring > Cooling > NetCol8000-A1.
NO TE
1 in NetCol8000-A1 is variable and subject to change with the smart cooling product
model and connection sequence. The displayed value may vary.
On the Running Parameters tab page, set smart cooling product running
parameters.
On the Controls tab page, set the smart cooling product control parameters
(such as on/off control parameters).
Copyright © Huawei Technologies Co., Ltd.
8 FAQ
330