Third-Party Nms Management (Over Snmp); Connecting A Communications Cable; Setting Snmp Management Parameters - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
Table 6-65 Connection modes
Connection Mode
Compatible
Security protocol
Step 16 After the setting is complete, click OK.
----End

6.14.2 Third-party NMS Management (over SNMP)

6.14.2.1 Connecting a Communications Cable

Procedure
Step 1 Connect a communications cable to the WAN1 port on the ECC800-Pro.
Figure 6-111 Connecting a communications cable
----End

6.14.2.2 Setting SNMP Management Parameters

Prerequisites
Before setting SNMP parameters, obtain the information listed as follows from the
NMS.
Issue 04 (2021-10-09)
Description
● On the ECC800-Pro WebUI, set Enable Security
Authentication to Disable.
● In transparent transmission channel management
settings, the compatibility mode has security
risks. You are advised to select the security
protocol mode.
Enter the authentication password set on the
ECC800-Pro WebUI.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
271