Commissioning A C3220 Camera - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual

6.5.3.3 Commissioning a C3220 Camera

Prerequisites
●
●
●
Context
●
●
●
●
Table 6-23 IP address planning
Device
Camera
VCN/
IVS1800
Procedure
Step 1 Log in to the camera web system and enable ONVIF.
1.
2.
3.
Issue 04 (2021-10-09)
If multiple cameras are connected, commission one camera first and then
commission other cameras in the same way.
The camera has connected to the smart ETH gateway and the smart ETH
gateway communicates properly with the ECC800-Pro.
The camera software version is later than SDC 8.0.RC111.
Before commissioning the C3220 camera, set the IP address for the C3220
camera based on customer requirements.
Configure the internal IP addresses of the camera and VCN or IVS1800 and
the IP address of the LAN port on the ECC800-Pro in the same network
segment.
Configure the external IP addresses of the camera and VCN or IVS1800 and
the IP address of the WAN1 port on the ECC800-Pro in the same network.
Set the internal and external IP addresses as planned by the customer. The
following IP addresses are for reference only.
Internal IP Address
Example: 192.168.248.50; range:
192.168.248.50–192.168.248.199
Example: 192.168.248.51; range:
192.168.248.50–192.168.248.199
Remove the network cables that connect the smart ETH gateway to the LAN1
and LAN2 ports on the ECC800-Pro.
Use a network cable to connect the PC to the PoE port on the smart ETH
gateway. Then, set the local IP address of the PC to 192.168.0.11.
Remove the camera shell and press the reset button for 6s to 10s to restart
the camera.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
External IP Address
Camera external IP
address
NOTE
The 192.168.246.X
network segment
cannot be set.
VCN or IVS1800
external IP address
NOTE
The 192.168.246.X
network segment
cannot be set.
157