Huawei SmartDC V100R021C10 User Manual page 242

Data center controller

Hide thumbs Also See for SmartDC V100R021C10:

Table of Contents

ECC800 Data Center Controller

Step 1 Log in to the ECC800-Pro WebUI as an administrator.

Step 2 Choose System Settings > Linkage Control.

Step 3 In the Linkage Group area, click Add, enter Turn on lights if door open, and click

OK. A linkage group is added.

Step 4 In the linkage group list, select the new linkage group and click Linkage Logic List

to expand the linkage logic list.

Step 5 In the Linkage Logic List area, click Add, set the linkage logic listed in the

following table, and click Submit.

Table 6-45 Linkage logic 1

Signal-Access

Actuator Group-

Collection-Door

Figure 6-84 Linkage logic diagram

Step 6 Set Turn on lights if door open to on to make the linkage logic take effect.

Issue 04 (2021-10-09)

Table of Contents