Commissioning A C3220 Camera (Sd Card Configured) - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
----End
Follow-up Procedure
Commission other cameras by referring to this section.

6.5.4.4 Commissioning a C3220 Camera (SD Card Configured)

Context
If the VCN or IVS1800 is not configured and an SD card is chosen, perform the
following procedure.
Procedure
Step 1 Log in to the Huawei camera WebUI.
1.
2.
Step 2 For details about how to commission the camera and set parameters, see the
documents delivered with the device or the documents obtained by referring to
the "Preparing Documentation" section.
1.
2.
Issue 04 (2021-10-09)
Parameter
Layered
encoding
JPEG quality
Configure the PC IP address and the camera IP address in the same network
segment. Enter the camera IP address (192.168.0.120 by default) in the
address bar of the Internet Explorer and press Enter.
Set the password as prompted upon the first login. Then use the new
password to log in.
Preview the site situation in real time and check the camera coverage through
videos. Adjust the lens if necessary.
Set IPv4 address, IPv4 subnet mask, and IPv4 gateway address to the
planned values.
Copyright © Huawei Technologies Co., Ltd.
Description
This parameter is available only when you set Encoding
protocol to H.264 or H.265.
To enable layered encoding, select Layered encoding.
This parameter is available only when you set Encoding
protocol to MJPEG.
A larger value indicates higher image quality.
6 Feature Description
185