Huawei SmartDC V100R021C10 User Manual page 61

ECC800 Data Center Controller
User Manual
Specifications
Table 3-41 AC actuator technical specifications
Item
Power input
Power output
Wireless
communication
RS485 serial
port
AI/DI detection
PAD intelligent
charging
BLINK button
Indicators
Table 3-42 AC actuator indicators
Indicator
Power
RUN
Issue 04 (2021-10-09)
Specifications
One AC input, 100 V AC to 240 V AC.
● AC OUT1: two AC outputs, 100 V AC to 240 V AC. The
maximum current of two outputs is 5 A.
● AC OUT2: one AC output, 100 V AC to 240 V AC, maximum
current: 5 A.
One wireless communication port that complies with
IEEE802.15.4
One route of dual RS485 ports, not isolated (reserved)
Two AI/DI dry contacts, connecting to two light buttons
Charging stops when the PAD battery level reaches 100%.
When the battery level is lower than 40% (default value,
which can be set to 30, 40, or 50), charging starts.
● Press the button for less than 1 second to start blinking.
● Hold down the button for 1–5 seconds to search for a
network and start networking.
● Hold down the button for more than 10 seconds to clear
network parameters.
Color Name
Green Power
status
indicator
Green Running
status
indicator
Copyright © Huawei Technologies Co., Ltd.
Status Description
Steady on The power input is normal.
Off There is no power input.
Off The power is abnormal or the
board program is loading.
Blinking at The AC actuator successfully
long registers with the ECC800-Pro
intervals and the software runs properly
(the indicator blinks at 0.5 Hz,
on for 1s and then off for 1s).
3 Device Description
49