Huawei SmartDC V100R021C10 User Manual page 136

ECC800 Data Center Controller
User Manual
Step 3 Set device addresses for cabinet electronic clasp locks.
●
●
●
●
Table 5-16 Setting device addresses
Address
1
2
3
4
5
6
7
8
9
10
11
12
Step 4 Add cabinet electronic clasp locks.
1.
2.
3.
Issue 04 (2021-10-09)
A cabinet electronic clasp lock is installed at the front and rear doors of each
IT cabinet respectively. The address for the cabinet electronic clasp lock on the
front door is an odd number, and that for the cabinet electronic clasp lock on
the rear door is an even number.
Mount the cabinet electronic clasp locks to the cabinets from left to right in
ascending order of the DIP switch addresses in the plan view. If the DIP switch
addresses are the same, mount the cabinet electronic clasp locks to the
cabinets in ascending order of the COM ports connected to the locks.
The DIP addresses of the cabinet electronic clasp locks start from 1. Each
COM port on the ECC800-Pro supports a maximum of 12 cabinet electronic
clasp locks connected in series.
Set a device address for a cabinet electronic clasp lock by operating the DIP
switch on the cabinet electronic clasp lock. Toggle switches 1 to 6 specify the
device address in binary mode. ON indicates 1, and OFF indicates 0.
Toggle Toggle
Switch 1 Switch 2
ON OFF
OFF ON
ON ON
OFF OFF
ON OFF
OFF ON
ON ON
OFF OFF
ON OFF
OFF ON
ON ON
OFF OFF
Log in to the ECC800-Pro WebUI as an administrator.
Create a cabinet view in Smart Module View on the home page.
Add a cabinet electronic clasp lock.
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle
Switch 3 Switch 4
OFF OFF
OFF OFF
OFF OFF
ON OFF
ON OFF
ON OFF
ON OFF
OFF ON
OFF ON
OFF ON
OFF ON
ON ON
5 Power-On Commissioning
Toggle Toggle
Switch 5 Switch 6
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
124