How Can I Set And Add A Smartli (Modbus-Tcp); How Can I Add And Set The Smart Module Actuator (Modbus-Mac) - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
----End

8.7.11 How Can I Set and Add a SmartLi (Modbus-TCP)?

Prerequisites
One end of the straight-through cable has been connected to the FE port on the
SmartLi and the other end has been connected to the PoE port on the smart ETH
gateway.
Procedure
Step 1 Set SmartLi monitoring parameters.
1.
2.
3.
----End
8.7.12 How Can I Add and Set the Smart Module Actuator
(Modbus-MAC)?
Prerequisites
One end of the straight-through cable has been connected to the LAN port on the
smart module actuator, and the other end has been connected to the PoE port on
the smart ETH gateway.
Procedure
Step 1 Log in to the ECC800-Pro WebUI as an administrator.
Step 2 Open the aisle door.
Issue 04 (2021-10-09)
– If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
On the home screen of the SmartLi, tap System Info.
Choose System Info > Settings, enter the user name admin and password
000001, and tap
Tap Communication to set IP address assign to Automatic(DHCP) on the
displayed communication settings screen and the SmartLi is discovered by
ECC800-Pro automatically and is connected to the ECC800-Pro.
NO TE
The following describes how to remotely open a door.
Copyright © Huawei Technologies Co., Ltd.
.
8 FAQ
315