How Can I Set And Add An Ats - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
3.
----End

8.7.16 How Can I Set and Add an ATS?

Prerequisites
One end of the straight-through cable has been connected to the COM port on
the ATS, and the other end has been connected to the COM port on the ECC800-
Pro collector or ETH converter.
Context
The ATS (ABB) model is OMD800.
Procedure
Step 1 Set the ATS device address. On the ATS display panel, tap
Configuration > Modbus and set the device address.
Step 2 Add an ATS.
1.
Issue 04 (2021-10-09)
Path Parameter
parameters Connect To
for adding
devices are
Communicati
displayed.
ons Port
Device
Address
Click Test Connect to check whether the PDU2000 is properly connected to
the ECC800-Pro.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
– If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
NO TE
● The ATS device address is 1 by default.
● The initial password is 0001 for the ATS display panel.
Log in to the ECC800-Pro WebUI as an administrator.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select ECC800 from the drop-down list
box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the
PDU2000 is connected to the COM1 port on the
ECC800-Pro. If the PDU2000 is connected to
another port, select the number of the
connected port.
Enter the actual device address of the
PDU2000.
8 FAQ
, choose Device
322