Networking Iboxs And Ibats In Wireless Mode - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
Parameter
Current source
Battery string
No.
----End

6.9.2 Networking iBOXs and iBATs in Wireless Mode

Prerequisites
Before networking, ensure that all the iBOXs and iBATs have no network
parameters, that is, the RF_Z indicator on the iBOX is steady green and the
RUN/ALM indicator on the iBAT is steady red.
Context
●
●
Procedure
Step 1 Press the networking switch on the iBOX for 2 seconds. The ALM indicator blinks
red once, and the RF_Z indicator turns from steady green to blinking green at
super short intervals, which indicates that the iBOX is being networked.
Step 2 Press the iBAT networking switch for 2 seconds. When the RUN/ALM indicator
turns from steady red to blinking green at super short intervals (iBattery 2.0) or
short intervals (iBattery 3.0), and finally to blinking green at long intervals, the
iBAT connects to the iBOX network.
Issue 04 (2021-10-09)
Description
0–xxxA Hall
The actual specifications of the Hall
effect sensor prevail.
Set this parameter based on the
planned codes for iBOXs and
battery strings.
NO TE
● The iBAT is connected to the iBOX in RF_Z networking mode.
● If the RF_Z indicator on the iBOX is not steady on (green), press and hold down the
networking switch on the iBOX for 10–20 seconds to clear the original network.
● If the RUN/ALM indicator on the iBAT is not steady red, hold down the iBAT networking
switch for at least 5 seconds to clear the original network.
If multiple iBOXs are connected, commission the iBOX one by one in the same
way. Otherwise, networking may be in disorder.
Indicator status:
– Blinking at long intervals: The indicator is on for 1 second and then off
for 1 second alternately.
– Blinking at super short intervals: The indicator is on for 0.05 seconds and
then off for 0.05 seconds alternately.
– Blinking at short intervals: The indicator is on for 0.125 seconds and then
off for 0.125 seconds alternately.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
Remarks
-
Set this parameter
based on the
customer's plan.
241