Huawei SmartDC V100R021C10 User Manual page 380

ECC800 Data Center Controller
User Manual
Context
Figure 8-26 Networking scenario
Procedure
Step 1 Ensure that the device communication mode has been set to DHCP.
Step 2 Log in to the ECC800-Pro WebUI as an administrator, and check whether the
device exists on the Monitoring page.
●
●
----End
Follow-up Procedure
Choose Home > Plan View on the ECC800-Pro WebUI, and drag the device to the
corresponding position in the Smart Module View pane based on the actual
device layout.
Issue 04 (2021-10-09)
If the device exists, and communication status is normal, the device has
accessed the ECC800-Pro successfully.
Figure 8-27 Device accessed the ECC800-Pro
If the device does not exist, check that the cable is properly connected
between the device and the ECC800-Pro, the ECC800-Pro is operating
properly, and communications parameters are set correctly.
Copyright © Huawei Technologies Co., Ltd.
8 FAQ
368