How Can I Set And Add A Dc Pdf (Modbus-Rtu) - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
----End

8.7.10 How Can I Set and Add a DC PDF (Modbus-RTU)?

Prerequisites
One end of the straight-through cable has been connected to the RS485/RS232
port on the power distribution monitoring unit in the DC PDF, and the other end
has been connected to the COM port on the ECC800-Pro collector or UIM20A.
Procedure
Step 1 Add a DC PDF (Modbus-RTU).
1.
2.
3.
Issue 04 (2021-10-09)
properly, and whether the parameter settings are consistent with the
device parameters.
Log in to the ECC800-Pro WebUI as an administrator.
Add a DC PDF.
Table 8-10 Adding a DC PDF
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device.
Communicati
ons Port
Device
Address
Click Test Connect to check whether the DC PDF is properly connected to the
ECC800-Pro.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select PDU from the drop-down list box.
Select TP48202BDCEndCabinet from the
drop-down list box.
Select ECC800 from the drop-down list
box.
NOTE
If the other end of the straight-through cable is
connected to the COM port on the UIM20A,
select UIM.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the
TP48202B DC end cabinet is connected to the
COM1 port on the ECC800-Pro. If the cabinet is
connected to another port, select the number of
the connected port.
In this example, Device Address is set to
160. During actual configuration, set the
device address for the DC PDF based on
the actual situation.
8 FAQ
314