Setting Neteco Parameters - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
Figure 6-108 Installing a 4G antenna
----End

6.14.1.2 Setting NetEco Parameters

Procedure
Step 1 Apply for a fixed IP address to the equipment room network administrator.
Step 2 Set ECC800-Pro communications parameters.
●
Issue 04 (2021-10-09)
(WAN port networking) On the ECC800-Pro WebUI, set the IP address, subnet
mask, and default gateway, and click Submit.
Table 6-60 IP parameters
Path Param
eter
System IP
Settings > addres
System s
Paramete
rs >
Monitor
Subnet
IP >
mask
WAN_n
NOTE
WAN_2 is
not
involved
Defaul
in the
t
FusionMo
dule500/8 gatew
00
ay
scenario.
Copyright © Huawei Technologies Co., Ltd.
Default Value
– WAN_1: 192.168.8.10
– WAN_2: 192.168.0.10
255.255.255.0
– WAN_1: 192.168.8.1
– WAN_2: 192.168.0.1
6 Feature Description
Setting
Set this parameter
based on the IP
address assigned by
the network
administrator.
Set this parameter
based on the subnet
mask assigned by the
network
administrator.
Set this parameter
based on the default
gateway address
assigned by the
network
administrator.
265