Setting Parameters On The Vcn Webui - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
Figure 6-55 RAID group status of disks that work independently (one disk)
----End

6.5.5.3 Setting Parameters on the VCN WebUI

Prerequisites
For details about the VCN hardware description and installation, see the
"Hardware Guide" in the corresponding VCN product documentation. For details
about the VCN configuration, see
Context
A default IP address has been configured for the VCN before delivery. Modify the
IP address based on the actual network plan.
Procedure
Step 1 Modify the IP address for the VCN.
1.
Issue 04 (2021-10-09)
NO TE
● After a RAID 1 is created for the system partition, the system partition's RAID group is in
data restoration state. At this time, one disk is synchronizing data in the system
partition to the system partition of another disk. The synchronization process takes
about 20 hours, which does not impact services. During this process, do not remove and
insert disks.
● If the OMU portal stays at the Local Disk tab page, even if users do not perform any
operation for a long period of time, the OMU portal will not automatically return to the
login page. For service security reasons, if users do not perform any operation for a long
period of time, the OMU portal will return to the login page or does not stay at the
Local Disk tab page.
NO TE
The version number is subject to the
and link in this document are for reference only.
Configure the PC IP address and the VCN IP address in the same network
segment. Enter the OMU Portal address (the default address for VCN500 is
https://192.168.1.100:8443; the default address for VCN510&VCN520&VCN540
is https://192.168.2.101:8443) in the address bar of the Internet Explorer and
press the Enter button.
Copyright © Huawei Technologies Co., Ltd.
Configuration Guide.
Quick Start delivered with the VCN. The description
6 Feature Description
194