Remote Management; Neteco Management; Connecting The Communications Cable; Setting Neteco Parameters - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual

6.9 Remote Management

6.9.1 NetEco Management

6.9.1.1 Connecting the Communications Cable

Procedure
Step 1 Connect the communications cable to the WAN_1 port on the ECC800.
Figure 6-49 Connecting the communications cable
----End

6.9.1.2 Setting NetEco Parameters

When the smart module can be connected to the NetEco, perform the following steps to
configure parameters.
Procedure
Step 1 Apply for a fixed IP address to the equipment room network administrator.
Step 2 Set the IP address, subnet mask, and default gateway on the ECC800 WebUI.
Table 6-31 IP parameters
Path
System
Settings >
System
Parameters
> Monitor
IP >
WAN_1
Step 3 Click Submit.
Issue 05 (2019-09-16)
Parameter Default
Value
IP 192.168.1.10
Subnet mask 255.255.255.
0
Default 192.168.1.1
gateway
Copyright © Huawei Technologies Co., Ltd.
Setting
Set this parameter based on the IP address
assigned by the network administrator.
Set this parameter based on the subnet mask
assigned by the network administrator.
Set this parameter based on the default
gateway address assigned by the network
administrator.
6 Feature Description
157