How Do I Set And Add An Ats - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Table 8-9 Adding a PDU2000
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
----End

8.1.6.9 How Do I Set and Add an ATS?

Prerequisites
One end of the straight-through cable has been connected to the COM port on the ATS, and
the other end has been connected to the COM port on the ECC800-Pro collector or ETH
converter.
Context
The ATS (ABB) model is OMD800.
Procedure
Step 1 Set the ATS device address. On the ATS display panel, press
Configuration > Modbus and set the device address.
Issue 06 (2020-04-22)
Parameter
Device attribute
Device type
Connect to
Communications
port
Device address
Click Test Connect to check whether the PDU2000-M connects to the ECC800-Pro
properly.
If the PDU2000 connects to the ECC800-Pro properly, click Confirm. The
−
connected devices are displayed in the Number of connected devices list.
− If the PDU2000 does not connect to the ECC800-Pro properly, check whether the
cable between the PDU2000 and the ECC800-Pro is connected properly, whether
the PDU2000 and ECC800-Pro are running properly, and whether the input
parameters are consistent with the PDU2000 parameters.
 The ATS device address is 1 by default.
 The initial password is 0001 for the ATS display panel.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select PDU from the drop-down list box.
Select PDU2000-M (C) or PDU2000-M (H) from
the drop-down list box based on the actual device.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the PDU2000 is
connected to the COM1 port on the ECC800-Pro. If the
PDU2000 is connected to another port, enter the number
of the connected port.
Enter the actual device address of the PDU2000.
8 FAQ
, choose Device
237