Networking Iboxs And Ibats In Wireless Mode - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Step 3 Click Unhide All Advanced Signals, set iBOX single battery qty., Batt. installation time,
Single battery capacity, Current source, and Battery string No.. Retain default values for
other parameters.
Table 6-24 Setting iBOX parameters
Parameter
iBOX/CIM single
battery qty.
Batt installation
time
Single battery
capacity
Current source
Battery string No.
----End

6.5.2 Networking iBOXs and iBATs in Wireless Mode

Prerequisites
Before networking, ensure that all the iBOXs and iBATs have no network parameters, that is,
the RF_Z indicator on the iBOX is steady green and the RUN/ALM indicator on the iBAT is
steady red.
Context


Issue 05 (2019-09-16)
Description
Total number of batteries monitored by
the iBOX/CIM
Actual time at which batteries are
installed
Single battery capacity refers to the
capacity of a single battery in a battery
string managed by the iBOX.
0–xxxA Hall
The actual specifications of the Hall
effect sensor prevail.
Set this parameter based on the planned
codes for iBOXs and battery strings.
 The iBAT is connected to the iBOX in RF_Z networking mode.
 If the RF_Z indicator on the iBOX is not steady on (green), press and hold down the networking
switch on the iBOX for 10–20 seconds to clear the original network.
 If the RUN/ALM indicator on the iBAT is not steady red, hold down the iBAT networking switch for
at least 5 seconds to clear the original network.
If multiple iBOXs are connected, commission the iBOX one by one in the same way.
Otherwise, networking may be in disorder.
Indicator status:
− Blinking at long intervals: The indicator is on for 1 second and then off for 1 second
alternately.
− Blinking at super short intervals: The indicator is on for 0.05 seconds and then off
for 0.05 seconds alternately.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
Remarks
Set this parameter based
on the battery parameter
planned by the customer.
-
Obtain the battery capacity
from the battery label or
document.
-
Set this parameter based
on the customer's plan.
138