General Information; Traction Unit Operator's Manual; Electrical Components And Schematic; Air Conditioning System - Toro Groundsmaster 360 Service Manual
4-wheel drive models with yanmar engine
Hide thumbs
Also See for Groundsmaster 360:
- Service manual (341 pages) ,
- Operator's manual (72 pages) ,
- Installation instructions manual (8 pages)
Table of Contents
Advertisement
General Information
Traction Unit Operator's Manual
Electrical Components and Schematic
Air Conditioning System
Cab Heater System
Operator Cab: General Information
The information in this chapter pertains to the operator cab of the Groundsmaster
360 machine.
The Operator's Manual provides information regarding the operation, general
maintenance, and maintenance intervals for your machine. Refer to the
Operator's Manual for additional information when servicing the machine.
Information regarding the Groundsmaster 360 electrical cab components
(switches and relays) are included in
The Electrical Schematics and Wire Harness Drawings for the operator cab in
Appendix A (page
A–1)—Foldout Drawings.
The air conditioning system used on the Groundsmaster 360 machine consists
of the following components:
1. A compressor mounted on the right side of the engine and driven by a V-belt.
2. A condenser assembly and 2 condenser fans located at the rear of the cab
roof assembly.
3. An evaporator core, a drier-receiver, and an expansion valve mounted in the
headliner of the cab.
4. The necessary hoses and tubes that connect the air conditioning system
components.
5. A blower fan motor that provides air movement through the evaporator and
into the cab. The fan motor is a component of the mixing box located in the
cab headliner and is also used for the cab heating system.
6. The operator controls to turn the air conditioning on to adjust the fan speed,
and to control the cab air temperature.
The cab heater system used on the Groundsmaster 360 machine consists of the
following components:
1. A heater core located in the headliner of the cab.
2. The hoses to allow a circuit for engine coolant to circulate through the heater
core.
3. A blower fan motor that provides air movement through the heater core and
into the cab. The fan motor is a component of the mixing box located in the
cab headliner and is also used for the air conditioning system.
4. The operator controls to adjust the fan speed and to control the cab air
temperature.
Chapter 5: Electrical System (page
Page 8–2
5–1).
Groundsmaster 360
16225SL Rev C
Advertisement
Chapters
Table of Contents
Troubleshooting
