Toro Groundsmaster 360 Service Manual page 225

Removing the Lift Cylinder (continued)
Installing the Lift Cylinder
Groundsmaster 360
16225SL Rev C
6. Install clean caps or plugs in the hose openings to prevent system
contamination.
7. Remove the retaining ring (item 3 in
the cylinder shaft that secures the lift cylinder head to the machine frame.
8. Pull the shaft from the lift cylinder and frame. Locate and retrieve the second
washer. Do not remove second retaining ring from the shaft.
9. Remove the shoulder bolt (item 6 in
that secure the lift cylinder rod end to the lift shaft assembly.
10. Remove the lift cylinder from the machine.
11. If necessary, remove the hydraulic fittings from the lift cylinder
12. Remove and discard the O-rings from the fittings.
1. If the hydraulic fittings were removed from the lift cylinder, lubricate and install
new O-rings to the fittings. Install the fittings into the lift cylinder ports and
torque the fittings to 20 to 25 N∙m (15 to 19 ft-lb).
2. Position the lift cylinder to the machine.
Note: The cylinder head should be attached to the machine frame.
3. Secure the cylinder rod end to the lift shaft assembly with the pivot pin (item
4 in Figure 153) and shoulder bolt.
4. Align the lift cylinder to the frame mounting holes. Slide the cylinder shaft
(item 1 in Figure 153) (with a washer and retaining ring installed on the one
end) through the lift cylinder and frame. Install the second washer on the
shaft and secure the shaft with the second retaining ring.
5. Remove the caps or plugs that were installed to the hydraulic hoses during
the removal process.
6. Use the labels that you attached during the lift cylinder removal to correctly
connect the hydraulic hoses to the lift cylinder fittings; refer to
Hydraulic Hose and Tube (O-Ring Face Seal Fitting) (page
7. Lubricate the grease fittings on the lift cylinder and pivot pin.
8. Ensure that the hydraulic tank is full. Add correct quantity of fluid if necessary;
refer to the Operator's Manual.
Figure
Figure
Page 4–167
153) and washer from one end of
153) and pivot pin
(Figure
Installing the
4–8).
Hydraulic System: Service and Repairs
154).