Toro Groundsmaster 360 Service Manual page 46

Removing the Radiator (continued)
Diesel Engine: Service and Repairs
• The upper radiator hose (item 19 in
water pump.
• The lower radiator hose (item 25 in
engine block.
• The coolant hose (item 5 in
reservoir assembly.
6. Clean the hydraulic hose ends and oil cooler fittings to prevent hydraulic
system contamination.
7. Disconnect the upper hydraulic tube from the straight hydraulic fitting (item
30 in Figure 10). Disconnect the lower hydraulic tube from the 45° hydraulic
fitting in the oil cooler and completely drain the hydraulic fluid from the oil
cooler into a suitable container.
8. Remove the fan shroud as shown in
shroud away from the radiator and ensure that you do not damage the fan.
9. Remove the 2 flange-head screws (item 21 in
that attach the radiator support to the radiator frame, and remove the radiator
support.
10. Carefully remove the oil cooler and radiator assembly from the machine.
11. Cover or plug the openings in oil cooler, radiator, and the disconnected
coolant and hydraulic hoses to prevent contamination.
12. If necessary, separate the oil cooler from the radiator as follows:
A. Remove the 4 screws (item 4 in
washers, and 4 hex nuts that attach the oil cooler to the radiator.
B. Separate the oil cooler from the radiator.
C. If the hydraulic fittings are to be removed from the oil cooler, mark the
fitting orientation for assembly purposes.
D. Remove the fittings from the oil cooler as necessary
discard the O-rings from the fittings.
E. For inspection procedure of oil cooler; refer to
(page 4–178).
Note: Remove any sealant found between the oil cooler and radiator.
13. Check the condition of the rubber isolator mounts (item 3 in
replace the mounts if damaged.
14. Check the condition of the bulb seals (items 16 and 17 in
replace the bulb seals if damaged.
Figure
Figure
Figure 10) that is connected to the coolant
Figure
Figure
Page 3–14
10) that is connected to the
10) that is connected to the
10. Carefully position the fan
Figure 10) and 2 flange nuts
11), 8 flat washers, 4 lock
(Figure 10) and
Inspecting the Oil Cooler
Figure
Figure 10) and
Groundsmaster 360
16225SL Rev C
10) and