Toro Groundsmaster 360 Service Manual page 254

Machine Faults (continued)
Engine Faults
Electrical System: InfoCenter Display
3. Allow the machine to remain O
4. Restart the engine and check the machine operation.
5. If a fault continues to occur, further system evaluation and possible
component repair or replacement will be necessary
To view a description of a fault that has occurred since the faults were last
cleared from the InfoCenter, press the down button (as indicated by the
the bottom of the screen) to highlight the desired fault, then press the left/right
button (as indicated by the
To return to the previous screen, press the menu/back button (as indicated by
the at the bottom of the screen).
Clear System Faults (PIN required) If the correct passcode (PIN) has been
entered (refer to the Protected Menus in the
InfoCenter fault log can be cleared by selecting Clear System Faults. The cleared
faults will be removed from the InfoCenter list but will be retained in the TEC
memory. Contact your Toro Distributor to view faults stored in the TEC memory.
g187359
Yanmar Diesel Engines – If an engine fault occurs during machine operation, the
fault indicator will illuminate and the fault will be displayed on the InfoCenter to
notify the operator (Figure
the offending condition is corrected. Once the offending condition has been
corrected, the engine fault will be retained in the engine electronic control unit
(ECU) and can only be viewed using the engine diagnostic tool. Engine faults
are not stored in the Toro Electronic Controller (TEC) so that the engine fault
history cannot be viewed using the InfoCenter faults screen.
Note: Refer to the Yanmar Engine Service Manual and Troubleshooting Manual
for additional information.
for at least 1 minute.
FF
).
Settings Screen (page
Figure 176
176). The engine fault will continue to appear until
Page 5–18
at
5–24)) the
Groundsmaster 360
16225SL Rev C