Toro Groundsmaster 360 Service Manual page 296

Testing the Key Switch (continued)
Electrical System: Testing the Electrical Components
multimeter (ohms setting), test the switch functions to determine if continuity
exists between the various terminals for each switch position. Check the
continuity between the switch terminals.
8. Replace the key switch if testing determines that it is damaged.
9. If the key switch testing is correct and a circuit problem still exists, check
the wire harness; refer to the Electrical Schematics and Wire Harness
Drawings/Diagrams in
10. After you complete the testing, connect the machine wire harness connector
to the key switch.
11. Secure the control panel to the machine with the removed fasteners; refer
to Assembling the Control Console (page
Circuit Logic Table
Switch Position
O
FF
R
UN
S
TART
Note: The key switch terminals 1 and 6 are connected internally. The terminals
4 and 5 are also connected internally. These terminals should have continuity
regardless of the switch position.
Appendix A (page A–1)—Foldout Drawings.
6–54).
Page 5–60
Circuits
1+6
1+3+4+5+6
1+2+4+5+6
Groundsmaster 360
16225SL Rev C