Toro Groundsmaster 360 Service Manual page 153

Removing the Transmission (continued)
g036462
1. Transmission
2. O-ring
3. Spline coupler
4. Gear pump assembly
5. O-ring
6. 90° hydraulic fitting
7. O-ring (3 each)
8. Flat washer (2 each)
9. Lock washer (2 each)
10. Bolt (2 each)
Installing the Transmission
Groundsmaster 360
16225SL Rev C
17. Inspect the flywheel housing and coupler on the engine flywheel for wear
or damage.
18. If necessary, remove the gear pump from the transmission; refer to
the Gear Pump (page
19. Remove the oil filter from the transmission and discard the filter.
11. Tee fitting
12. O-ring (2 each)
13. Straight hydraulic fitting
14. O-ring (2 each)
15. Dust cap
16. O-ring (3 each)
17. Test nipple
18. O-ring (4 each)
19. 90° hydraulic fitting (3 each)
20. O-ring (3 each)
1. Ensure that the flywheel coupler and flywheel housing are secure on the
engine; refer to Installing the Engine (page
2. If the hydraulic fittings were removed from the transmission, lubricate and
install new O-rings to the fittings. Install the fittings into the transmission
4–137).
Figure 76
21.
22.
23.
24.
25.
26.
27.
28.
29.
Page 4–95
Straight fitting
O-ring
O-ring
Straight hydraulic fitting
90° hydraulic fitting
90° hydraulic fitting
O-ring
90° elbow fitting
Adapter hydraulic fitting
3–24).
Hydraulic System: Service and Repairs
Removing