Toro Groundsmaster 360 Service Manual page 151

Removing the Transmission (continued)
Groundsmaster 360
16225SL Rev C
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Remove the cutting deck; refer to the Cutting Deck Operator's Manual.
3. On the machines with operator cab, remove the cab doors from the cab.
4. Remove the operator seat and seat plate; refer to
Seat (page 6–60).
g036461
1. Screw (4 each)
2. Flange nut (4 each)
g036607
1. Seat channel
2. Flange nut (2 each)
5. Remove the power center assembly; refer to
Assembly (page 6–56)
to Removing the Power Center Assembly (page
Figure 74
3. Link assembly (2 each)
4. Neutral shaft assembly
Figure 75
3. Screw (2 each)
4. Flat washer (2 each)
or, if the machine is equipped with operator cab; refer
Page 4–93
Removing the Operator
Removing the Power Center
6–58).
Hydraulic System: Service and Repairs