Assembling the Transmission (continued)
Hydraulic System: Service and Repairs
g036300
1.
Hex nut
2.
Lock washer
3.
Washer
54. Lubricate the solenoid valve spring, sleeve, and spool with clean hydraulic
fluid and install the solenoid valve spring, sleeve, and spool into the pump
body.
Note: Ensure that the sleeve is installed so that the holes are closest to the
spring location and that the step in the spool is also toward the spring location.
55. Place the pin in the spool.
56. Install the solenoid valve stem into the pump body and torque the solenoid
valve stem to 21 to 22 N∙m (186 to 195 in-lb).
57. Install the O-ring, solenoid coil, O-ring, washer, lock washer, and nut onto the
solenoid valve stem; torque the nut to 5.9 to 7.8 N∙m (52 to 69 in-lb).
Note: The coil should be installed so that the "KANZAKI" molded into the coil
has the "I" nearest the nut location.
Figure 132
4.
Seal
5.
Solenoid valve coil
6.
Letter I
Page 4–128
Groundsmaster 360
16225SL Rev C