Table of Contents
Advertisement
Product Overview
Specifications
Note:
Specifications and design are subject to
change without notice.
Width
1.52 m (60 inches)
of Cut
Height
Adjustable from 19 to 102 mm (3/4 to 4 inches) in 13
of Cut
mm (1/2 inch) increments
Net
260 kg (573 lb)
Weight
Attachments/Accessories
A selection of the manufacturer approved attachments
and accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized the
manufacturer distributor or go to www.Toro.com for a
list of all approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
Operation
Cutting Unit General
Information
•
Keep the flail blades sharp and in good condition
to ensure good cutting performance, minimum
power consumption, and good quality of cut.
•
The cutting unit floats to follow ground contours.
•
Before engaging the cutting unit, ensure that the
engine is set to a reduced speed:
– Traction unit models 31900, 31901, 31907, and
31909: Refer to
before PTO Engagement (page 15)
– Traction unit models 31902 and 31903: Refer
to
Engaging the L
(page 15)
•
Operate the cutting unit at full engine speed.
Adjust the forward speed to suit the grass
conditions and to not overload the cutting unit.
The lower the forward speed, the better the quality
of cut and after-cut appearance.
Adjusting the Height of Cut
Important:
Always ensure that the height of cut
is set correctly according to these instructions.
Ensure that both the adjuster plate and the caster
fork spacers are set according to the table. Failure
to do this may cause premature wear in the
driveline and excessive vibration.
Note:
The height of cut is determined by the
rear roller and the front casters. Blade wear, tire
pressure, and bent/damaged caster arms can affect
the height-of-cut setting.
Some parts not shown for clarity.
1. Height of cut
2. Spacer
17
Reducing the Engine Speed
RPM PTO E
OW
NGAGE
Figure 18
3. Height-of-cut adjuster
plate
Mode
g384336
Advertisement
Table of Contents
