Toro Groundsmaster 360 Service Manual page 261

Settings Screen (continued)
Groundsmaster 360
16225SL Rev C
Units: Use the left/right button (as indicated by the
screen) to select between metric or English units of measure. Allow the desired
selection to remain in view for 5 seconds. The fault indicator will illuminate and
an operator advisory #180 (New Value Saved in Permanent Memory) will appear
on the InfoCenter display to confirm that the change has been recorded.
Language: Use the left/right button (as indicated by the
screen) to select from numerous language options. Allow the desired selection to
remain in view for 5 seconds. The fault indicator will illuminate and an operator
advisory #180 (New Value Saved in Permanent Memory) will appear on the
InfoCenter display to confirm that the change has been recorded.
Backlight: Press the left/right button (as indicated by the
the screen) then use the down button to decrease or the left/right button to
increase the InfoCenter display brightness (as indicated by the – and the + at the
bottom of the screen).
Contrast: Press the left/right button (as indicated by the
of the screen) then use the down button to decrease or the left/right button to
increase the InfoCenter display contrast (as indicated by the – and the + at the
bottom of the screen).
Protected menus: Authorized individuals can enter the 4 digit passcode (PIN)
to reveal the following service functions (refer to
Service Screen (page
•
Clear System Faults
•
Key On
•
4WS (4-Wheel Steer)
•
Service Reset
•
DPF Regeneration
•
DPF Ash
Entering the correct PIN will also reveal and allow adjustment of various machine
functions on the settings screen if Protect Settings is set to O
Protected Menus in the
Use the down button and left/right button (as indicated by the
the bottom of the screen) to enter the 4 digit passcode (PIN). Once the correct
PIN has been entered, press the down button (as indicated by the
bottom of the screen). PIN will appear in the upper right hand corner of the
InfoCenter display. The protected items will be visible as long as the key switch
remains in the R position.
UN
To edit the passcode (PIN), enter the current PIN as previously described (PIN
will appear in the upper right hand corner). Select Protected Menus again and
use the down button and left/right button (as indicated by the
the bottom of the screen) to enter a new 4 digit PIN. Press the down button to
save the change (as indicated by the
Note: The initial PIN will either be 1234 or 0000. If the PIN has been changed
and is forgotten, you can obtain a temporary PIN from your Toro distributor.
The following settings will only be visible if Protect Settings is set to O
correct passcode (PIN) has been entered, or Protect Settings is set to O
Protect settings: Use the left/right button (as indicated by the
of the screen) to select O
remaining settings will be visible and adjustable at all times. When the Protect
Settings is set to O , the remaining settings will be visible and adjustable only
N
5–19)):
Settings Screen (page
at the bottom of the screen).
or O . When the Protect Settings is set to O
FF N
Page 5–25
at the bottom of the
at the bottom of the
at the bottom of
at the bottom
Faults Screen (page 5–17)
(refer to the
N
5–24)).
and the
and the
at the bottom
Electrical System: InfoCenter Display
and
at
at the
at
and the
N
:
FF
, the
FF