Toro Groundsmaster 360 Service Manual page 135

Removing the Hydraulic Tank
Inspecting the Hydraulic Tank
Installing the Hydraulic Tank
Groundsmaster 360
16225SL Rev C
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Raise the operator seat.
3. Drain the hydraulic fluid from the hydraulic tank into a suitable container.
4. Remove the hydraulic tank cover from the machine; refer to
(page 6–53).
5. Clean the hydraulic hose ends and fittings on the hydraulic tank to prevent
contaminants from entering into the hydraulic system.
6. For assembly purposes, label all the hydraulic hoses and fittings. Remove
the hydraulic hoses from the fittings on the hydraulic tank
drain the hoses into a suitable container.
7. Install clean caps or plugs on the hydraulic hoses and fittings to prevent
system contamination.
8. Remove the 4 flange-head screws (item 15 in
hydraulic tank to the frame.
9. Remove the hydraulic tank from the machine.
10. Remove the hydraulic fittings from the hydraulic tank as necessary
62).
11. Remove and discard the O-rings from the fittings.
1. Clean the hydraulic tank and strainer fitting assembly with solvent.
2. Inspect the hydraulic tank for leaks, cracks, or other damage.
g036036
1. Hydraulic tank
2. Transmission
1. Install the strainer fitting assembly and fittings with new lubricated O-rings
to the hydraulic tank; refer to
Thread O-Ring Fitting into the Component Port) (page
fittings to the values identified in
Figure 63
3. Gear pump
Installing the Hydraulic Fittings (SAE Straight
Figure 62.
Page 4–77
Control Console
(Figure 63) and
Figure 62) that secure the
(Figure
4–9). Torque the
Hydraulic System: Service and Repairs