Toro Groundsmaster 360 Service Manual page 458

Removing the Air Conditioning Condenser Assembly (continued)
Operator Cab: Service and Repairs
Loosening any air conditioning system fitting or component allows
the pressurized refrigerant to escape, causing possible injury.
Do not loosen any system fitting or component until a certified air
conditioning service technician discharges the system completely.
g036618
1. Condenser core
2. Lower leg (2 each)
3. Hex nut (6 each)
4. Front wall
5. Back wall
6. Right side wall
5. Have a certified air conditioning service technician evacuate the refrigerant
from the air conditioning system.
6. Label and remove the hoses from the condenser core. Immediately install
the caps on the hoses and fittings to prevent moisture and contaminants
from entering into the system.
7. Remove the 4 flange nuts (item 6 in
conditioning condenser assembly to the cab frame.
8. Carefully raise the condenser assembly from the headliner and remove the
assembly from the machine.
9. Inspect the seals (items 7 and 8 in
wear or damage and replace the seals if necessary.
10. If necessary, disassemble the condenser assembly
11. Inspect the seals (items 8 and 9 in
assembly walls for wear or damage and replace the seals if necessary.
CAUTION
Figure 328
7. Left side wall
8. Strip seal (2 each)
9. Edge seal (2 each)
10. Screw (12 each)
11. Clip (16 each)
Figure
Figure 327) on the top of the cab frame for
Figure 328) on the top of the condenser
Page 8–18
327) that secure the air
(Figure 328).
Groundsmaster 360
16225SL Rev C