Toro Groundsmaster 360 Service Manual page 408

Removing the Power Center Assembly
Installing the Power Center Assembly
Chassis: Service and Repairs
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, shut off the engine, and remove the key from the key switch.
2. Disconnect the battery cables from the battery. Remove the negative battery
cable and then remove the positive cable; refer to
(page 5–110).
3. Unlatch the operator seat and raise it.
4. Unlatch and remove the power center cover (item 5 in
Note: To access machine components below the power center assembly, it
is possible to remove the cotter pins, clevis pins, and washers that secure
the power center to the seat channel. Then, the power center with all
attached electrical components can carefully be raised and supported to get
access below the power center. If complete removal of the power center is
necessary, continue with the following steps.
5. For assembly purposes, label all the wire harness connectors.
6. Disconnect all the wire harness connectors from the electrical components
attached to the power center assembly (item 16 in
7. Support the power center assembly and remove the 2 hairpin cotters (item
20 in Figure 295) and 2 clevis pins that secure the power center assembly to
the seat channel, and remove the power center assembly.
1. Position the power center assembly onto the seat channel.
2. Secure the power center assembly to the seat channel with the 2 hairpin
cotters (item 20 in
3. Use the labels that you attached during removal to connect all the wire
harness connectors to the electrical components attached to the power
center assembly.
4. Install and secure the power center cover with the 2 swell latches (item 2 in
Figure 295).
5. Lower the operator seat and latch it.
6. Connect the battery cables to the battery. Connect the positive cable and
then connect the negative cable; refer to
Figure 295) and 2 clevis pins.
Servicing the Battery (page
Page 6–56
Servicing the Battery
Figure 295).
Figure 295).
5–110).
Groundsmaster 360
16225SL Rev C