Toro Groundsmaster 360 Service Manual page 406

Disassembling the Control Console
Assembling the Control Console
Chassis: Service and Repairs
g037454
1. Control panel
2. Button-head torx screw (5 each)
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, shut off the engine, and remove the key from the key switch.
2. Disconnect the battery cables from the battery. Remove the negative battery
cable and then remove the positive cable; refer to
(page 5–110).
3. Remove the 5 screws that secure the control panel to the machine.
4. On machines with an operator cab, remove the 2 screws that secure the
access panel and then remove the access panel
5. Carefully lift and support the control panel to get access to the electrical
connections.
6. For assembly purposes, label all the wire harness connectors.
7. Disconnect the wire harness connectors from all the electrical components
on the control panel.
8. Remove the control panel from the machine.
9. If necessary, remove the hydraulic tank cover as shown in
1. If the hydraulic tank cover was removed, install the hydraulic tank cover as
shown in Figure 293.
2. Use the labels that you attached during disassembly to connect the wire
harness connectors to the components on the control panel.
3. On machines with an operator cab, position the access panel in place and
secure with the 2 screws
4. Position the control panel on the hydraulic tank cover and secure the control
panel with the 5 screws
5. Connect the battery cables to the battery. Connect the positive cable and
then connect the negative cable; refer to
Figure 294
3. Access panel
4. Screw (2 each)
(Figure 294).
(Figure 293).
Servicing the Battery (page
Page 6–54
Servicing the Battery
(Figure 294).
Figure 293.
5–110).
Groundsmaster 360
16225SL Rev C