Toro Groundsmaster 360 Service Manual page 415

Disassembling the Operator Seat
Groundsmaster 360
16225SL Rev C
g037458
1. Backrest knob
2. Seat suspension knob
1. Remove the operator seat from the machine; refer to
Seat (page 6–60).
2. Remove the armrest assemblies and then the back panel (item 5 in
299) from the back of the seat.
3. Carefully peel the label from the backrest knob, and remove the nut and
knob from the seat frame
4. Remove the 6 push clips that attach the back cushion (item 2 in
to the seat frame, and remove the back cushion.
5. Remove the 2 bolts that attach the bottom cushion (item 1 in
the seat frame, and remove the bottom cushion.
6. Remove the hex nut (item 15 in
adjustment knob to the weight adjust bar. Remove the adjustment knob
from the weight adjust bar to remove the tension of the cable. Remove the
cables from the spring saddle.
7. Remove the 18 push clips from the seat frame and separate the seat boot
(item 27 in Figure 299) from the frame.
8. Remove the 2 roll pins that attach the bearing shafts (item 14 in
to the seat frame, and remove the bearing shafts and split nylon bushings
from the frame.
9. Lift the seat frame from the suspension base (item 12 in
10. Remove the nut and bolt that attach the top of the shock absorber (item 10
in Figure 299) to the suspension base, and separate the top of the shock
absorber from the suspension base.
11. Slide the spring saddle (item 13 in
disengage the springs at top of the suspension base.
12. Remove the springs from the spring saddle. Note the orientation of the
springs and spring saddle for assembly purposes.
Figure 300
3. Lumbar support knob
4. Seat position lever
(Figure 300).
Figure 299) that secures the weight
Figure 299) from the spring arm while you
Page 6–63
Removing the Operator
Figure
Figure 299)
Figure 299) to
Figure 299)
Figure 299).
Chassis: Service and Repairs