Toro Groundsmaster 360 Service Manual page 280

Adjusting the Traction Neutral Sensor
Electrical System: Adjustments
1. Before adjusting the traction neutral sensor, check and adjust the traction
system neutral position; refer to the Operator's Manual.
2. Park the machine on a level surface, lower the cutting deck, and shut off
the engine.
3. Loosen both the jam nuts that secure the neutral sensor to the neutral end
plate.
4. Adjust the location of the neutral sensor as follows:
A. Turn the key switch to the R
B. Manually move the sensor towards the neutral arm and adjust the rear
jam nut until the LED on the cable end of the traction neutral sensor is
not illuminated.
C. Rotate the rear jam nut in the opposite direction until the LED illuminates.
Continue to rotate the rear jam nut 1 full turn.
D. Tighten the front jam nut to secure the sensor. Ensure that the sensor
position does not change. Torque the jam nut to 18.4 to 22.4 N∙m (162 to
198 in-lb).
To prevent the traction neutral sensor damage, ensure that the
sensor does not contact any machine components during the
traction pedal movement.
5. After adjustment to the traction neutral sensor, use the InfoCenter display
to verify that the traction neutral sensor and circuit wiring are functioning
correctly; refer to Using the InfoCenter Display for Troubleshooting (page
5–30).
position.
UN
IMPORTANT
Page 5–44 Groundsmaster 360
16225SL Rev C