Toro Groundsmaster 360 Service Manual page 58

Installing the Engine (continued)
Diesel Engine: Service and Repairs
12. On the machines with an operator cab:
A. Install the air conditioning compressor to the compressor bracket; refer to
Installing the Air Conditioning Compressor (page
compressor drive belt is properly tensioned.
B. Connect the cab heater hose to the engine thermostat housing
17).
13. Use the notes that you recorded during removal and connect all the electrical
connectors.
• Connect the Toro engine harness to Yanmar engine harness (4 multipin
connectors on the left side of the engine).
• Connect the wire harness connector to the oil pressure switch.
• Connect the wire harness to the starter "S" terminal.
• Connect the wire harness to the alternator (items 6,7, and 8 in
• Connect the wire harness to the DPF pressure sensor (item 3 in
and temperature sensors (items 1 and 2 in
• Connect the wire harness to the glow plug bus.
• Connect the battery positive cable and fusible link harness to the starter
solenoid post.
• Connect the negative battery cable to the engine block.
Note: When securing the negative battery cable (ground) to the engine,
ensure that the lock washer is between the ground cable and engine flange.
Torque the flange nut to 20 to 25 N∙m (175 to 225 in-lb) and apply a layer of
terminal protector (Toro Part No. 107-0392) to prevent corrosion.
14. Install the exhaust tube to the engine
15. Install the radiator and oil cooler assembly to the machine; refer to
the Radiator (page
16. Install the cross tube and air cleaner assembly as shown in
17. Connect both the battery cables to the battery. First, connect the positive
battery cable and then the negative battery cable; refer to
Battery (page 5–110).
18. Check the engine-oil level and adjust as necessary.
19. Install the hood; refer to
20. Ensure that all the hoses, tubes, and wires are clear of moving parts and
secured to their original locations.
21. Prime the fuel system; refer to
22. Operate the machine checking for coolant, hydraulic fluid or fuel leaks.
23. Check the engine coolant and hydraulic fluid levels before returning the
machine to service.
(Figure
3–15).
Installing the Hood (page
Priming the Fuel System (page
Page 3–26
8–8). Ensure that the
(Figure
Figure
Figure
Figure 16).
9).
Installing
Figure 15.
Servicing the
6–68).
3–17).
Groundsmaster 360
16225SL Rev C
16).
16)