Fan Speed Switch (Machines With Operator Cab) - Toro Groundsmaster 360 Service Manual

Fan Speed Switch (Machines with Operator Cab)

Testing the Fan Speed Switch
Groundsmaster 360
16225SL Rev C
g186593
1. Cab headliner (air/heat panel)
g186592
The fan speed switch is located in the cab headliner
used to select the air conditioning/heater fan speed (off, low, medium, or high).
1. Park the machine on a level surface, lower the cutting deck, and shut off the
engine. Remove the key from the key switch.
2. To access the switch, remove the roof panel from the top of the cab; refer to
Roof Assembly (page
3. Remove the air/heat panel from the cab headliner.
4. Disconnect the machine wire harness connector from the fan speed switch.
5. The switch terminals are identified in
switch is shown in the
multimeter (ohms setting), test the switch functions to determine if continuity
exists between only the terminals listed for each switch position. Check the
continuity between the switch terminals.
Figure 218
2. Fan speed switch
Figure 219
8–10).
Figure 219
Circuit Logic Table (page
Page 5–75 Electrical System: Testing the Electrical Components
(Figure 218). The switch is
and the circuitry of the
5–76). With the use of a