Fan Speed Switch - Toro Groundsmaster 360 Service Manual

Fan Speed Switch (Machines with Two−Post ROPS Extension
Operator Fan Kit)
g242793
1.

Fan speed switch

2. Control knob
Testing
Electrical System: Testing the Electrical Components
g242792
The fan speed switch is attached to the overhead control panel
switch is used to select the fan speed (OFF, LOW, MEDIUMOR HIGH).
1. Park the machine on a level surface, lower the cutting decks, and shut off
the engine. Remove the key from the key switch.
2. To access the switch, remove the sunshade from the top of the ROPS
extension.
3. Disconnect the machine wire harness from the fan speed switch.
4. The switch terminals are identified in
multimeter (ohms setting), test the switch functions to determine if continuity
exists between only the terminals listed for each switch position. Check the
continuity between the switch terminals.
Figure 242
3. Control panel
Figure 243
Back of Switch
(Figure
Page 5–100
(Figure 242). The
243). With the use of a
Groundsmaster 360
16225SL Rev C