Toro Groundsmaster 360 Service Manual page 284

Adjusting the Steering Home Sensor (continued)
Electrical System: Adjustments
position of the sensor bracket so that the sensor is directly over the target
bracket opening.
2. The gap between the steering home sensor and the target bracket should be
3.8 to 4.3 mm (0.150 to 0.170 inch). If necessary, loosen the jam nuts that
secure the sensor to the sensor bracket. Position the sensor with jam nuts
to allow correct gap between the sensor and the target bracket. Tighten the
jam nuts to secure the sensor adjustment. Torque the jam nuts to 18.4 to
22.4 N∙m (162 to 198 in-lb). After the jam nuts are tightened, ensure that
clearance between the head of the steering home sensor and the target
bracket has not changed.
3. After adjustment to the steering home sensor, use the InfoCenter display
to verify that the steering home sensor and circuit wiring are functioning
correctly; refer to Using the InfoCenter Display for Troubleshooting (page
5–30).
Page 5–48 Groundsmaster 360
16225SL Rev C