Toro Groundsmaster 360 Service Manual page 361

Aligning the Wheels (continued)
Groundsmaster 360
16225SL Rev C
Before lifting the machine with a jack, review and follow
Instructions (page 1–7).
4. Lift the machine with a jack until the 4 wheels are off the ground. Support
raised machine with appropriate jack stands.
5. Ensure that the steering cylinder rod ends (both front and rear) are properly
installed. The distance from the end of the cylinder shaft to the center of the
rod end grease fitting should be 44.5 mm (1.750 inches). If necessary, loosen
the rod end jam nut (item 1 in
end. After adjustment, torque the jam nut to 113 to 136 N∙m (83 to 101 ft-lb).
After installation of either of the steering alignment tools, do not
rotate the steering wheel. Rotating the steering wheel with either or
both of the alignment tools in place will damage the tools.
Note: Installation of steering alignment tools (
the machine ensures that the steering components are properly centered to
the machine so that correct wheel alignment can be achieved.
g037243
1. Rear axle
2. Rear center link
IMPORTANT
Figure 256) and adjust the location of the rod
IMPORTANT
Figure 257
3. Rear alignment tool
Page 6–9
Jacking
Special Tools (page 6–4)) to
Chassis: Adjustments