Toro Groundsmaster 360 Service Manual page 210

Installing the Steering Cylinder (continued)
Hydraulic System: Service and Repairs
C. Insert the cotter pins to secure the hex nuts.
7. Remove the caps and plugs from the hydraulic hoses and fittings.
8. Lubricate and install new O-rings on the steering cylinder fittings. Correctly
connect the hydraulic hoses to the steering cylinder; refer to
Hydraulic Hose and Tube (O-Ring Face Seal Fitting) (page
9. Check the hydraulic-fluid level in the hydraulic reservoir and add correct
quantity of fluid if necessary; refer to the Operator's Manual.
10. Lubricate the steering cylinder ball joint grease fittings.
11. Check that the steering cylinder does not contact the axle or frame as cylinder
moves from fully retracted to fully extended. Also, check that the distance
between the drag links and steering stops are equal on both sides of the
machine. If necessary, adjust the location of the rod end on the cylinder shaft.
12. If removed, secure the front cover to the front axle
13. If removed, secure the power center assembly to the machine; refer to
Installing the Power Center Assembly (page
assembly is just lowered, raise it to its original position. Lower the operator
seat.
Page 4–152
Installing the
4–8).
(Figure 146).
6–58), or if the power center
Groundsmaster 360
16225SL Rev C