Steering Column - Toro Groundsmaster 360 Service Manual

Steering Column

g036305
1. Steering column assembly
2. Steering wheel
3. Locknut
4. Steering wheel cover
5. Flat washer
Removing the Steering Column
Groundsmaster 360
16225SL Rev C
6. Flange-head screw (3 each)
7. Steering control valve
8. Carriage screw (4 each)
9. Alignment bushing
10. Mount (4 each)
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, and remove the key from the key switch.
2. Remove the steering wheel cover (item 4 in
wheel by carefully prying up on one of the cover spokes.
3. Remove the locknut (item 3 in
steering wheel to the steering column.
4. Use a suitable puller to remove the steering wheel (item 2 in
from the steering column assembly.
5. Slide the rubber bellows up to the steering column to get access to the
fasteners that secure the steering column to the machine.
6. Support the steering control valve (item 7 in
shifting during the steering column removal.
Figure 282
11.
12.
13.
14.
Figure 282) and flat washer that secure the
Page 6–41
Steering plate
Washer (4 each)
Flange nut (4 each)
Socket-head screw
Figure 282) from the steering
Figure
Figure 282) to prevent it from
Chassis: Service and Repairs
282)