Toro Groundsmaster 360 Service Manual page 57

Installing the Engine (continued)
Groundsmaster 360
16225SL Rev C
4. Support the transmission to prevent it from moving during the engine
installation.
Do not lift the engine with the lift eyes on the DPF.
5. Attach a suitable lift or hoist to the lift tabs on the front and rear of the engine.
Support the engine with lift or hoist to prevent the engine from shifting or
moving.
6. Carefully lower the engine into the machine, align the engine with the
transmission input shaft, and move the engine toward the flywheel housing.
g037254
1. Fuel supply hose
When installing the engine ensure that you do not damage the
engine, flywheel housing, fuel hoses, hydraulic lines, electrical
harness or other parts. Also, ensure that transmission does not
shift during engine installation.
7. Align the engine with the engine mounts and install a flange nut, snubbing
washer, and bolt through each of the 4 engine mounts but do not fully tighten
the flange nuts.
8. Align the flywheel housing with the engine and install the 9 screws (items 18
and 19 in Figure 14) and 9 lock washers Once all screws have been installed,
tighten the screws to secure the flywheel housing to the engine.
9. Tighten the bolt at each of the 4 engine mounts.
10. Remove all of the covers and plugs from the engine openings that you placed
while removing the engine.
11. Use the labels that you attached during removal to correctly connect the fuel
supply hose (item 1 in
IMPORTANT
Figure 18
2. Return hose
IMPORTANT
Figure 18) and return hose to the fuel filter.
Page 3–25 Diesel Engine: Service and Repairs