Toro Groundsmaster 360 Service Manual page 300

Testing the Deck Lift Switch (continued)
Electrical System: Testing the Electrical Components
6. Ensure that the key switch is in the O
electrical connector from the deck lift switch.
7. The deck lift switch terminals are identified in
the switch is shown in the
multimeter (ohms setting), test the switch functions to determine if continuity
exists between the various terminals for each switch position. Check the
continuity between the switch terminals.
Circuit Logic Table
Switch Position
R
AISE
O
FF
L
OWER
Note: The lift switch terminals 4, 5, and 6 are not used on the Groundsmaster
360 machines.
8. Replace the deck lift switch if testing determines that the switch is damaged.
9. If the deck lift switch testing is correct and a circuit problem still exists, check
the wire harness; refer to the Electrical Schematics and Wire Harness
Drawings/Diagrams in
10. After you complete the testing, connect the wire harness connector to the
deck lift switch.
11. Secure the control panel to the machine with the removed fasteners; refer
to Assembling the Control Console (page
position. Disconnect the wire harness
FF
Circuit Logic Table (page
Normal Circuits
2+1
None
2+3
Appendix A (page A–1)—Foldout Drawings.
6–54).
Page 5–64
Figure 208 and the circuitry of
5–64). With the use of a
Other Circuits
5+4
None
5+6
Groundsmaster 360
16225SL Rev C