Jacking Instructions; Raising The Front Of The Machine - Toro Groundsmaster 360 Service Manual

Jacking Instructions

Raising the Front of the Machine

Groundsmaster 360
16225SL Rev C
Failing to properly support the machine with appropriate jack stands
can cause the machine to move or fall and can result in personal
injury.
When changing the attachments, tires, or performing other services,
do the following steps:
• Use correct blocks, hoists, and jacks to raise and support the
machine.
• Park the machine on a solid level surface, such as a concrete
floor.
• Before you lift the machine, remove all the attachments that may
interfere with the safe and correct lift of the machine.
• Always block the wheels with chocks.
• Use appropriate jack stands to support the raised machine.
• Do not use the cutting deck or implement as a jacking point.
g188106
1. Front axle pivot
1. Set the parking brake and block the 2 rear tires with chocks to prevent the
machine from moving.
2. Position the jack securely under the front axle pivot.
3. Use a jack to raise the front of the machine.
Do not support the machine on the front steering fork or front wheel
motors.
4. After raising the front of the machine, use appropriate jack stands under the
frame to support the front of the machine.
CAUTION
Figure 2
2. Front tire
IMPORTANT
Page 1–7 Safety: Jacking Instructions